Aug 28, 2023 Reliable Study Materials for NSE7_SDW-7.0 Exam Success For Sure
100% Latest Most updated NSE7_SDW-7.0 Questions and Answers
Fortinet NSE7_SDW-7.0 certification is an industry-recognized certification that is highly valued by employers. It demonstrates that the certified professional has the technical expertise and knowledge to design and implement secure SD-WAN solutions. Fortinet NSE 7 - SD-WAN 7.0 certification is suitable for network security professionals, system administrators, and IT managers who want to expand their knowledge and skills in secure SD-WAN deployment and management.
Earning the Fortinet NSE7_SDW-7.0 Certification demonstrates that the IT professional has the knowledge and skills required to implement and manage Fortinet SD-WAN solutions effectively. It also validates the candidate's ability to design and configure secure, high-performance SD-WAN networks that meet the requirements of modern enterprise networks.
Fortinet NSE7_SDW-7.0 certification exam is a vendor-neutral certification, which means that it is recognized by a wide range of organizations and can be used to demonstrate expertise and knowledge in SD-WAN technologies. Fortinet NSE 7 - SD-WAN 7.0 certification is particularly valuable for network professionals who work in organizations that use Fortinet's SD-WAN solution, as it demonstrates a high level of proficiency and expertise in managing and configuring this solution.
NEW QUESTION # 18
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
- A. You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI template.
- B. You can configure advanced CLI settings.
- C. You can reference meta fields.
- D. You can configure interfaces as SD-WAN members without having to remove references first.
Answer: B,C
NEW QUESTION # 19 
Exhibit B -
Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-WAN zone for port1 and port2?
- A. port2 is referenced in a static route.
- B. port1 is assigned a manual IP address.
- C. port1 is referenced in a firewall policy.
- D. port1 and port2 are not administratively down.
Answer: C
NEW QUESTION # 20
Which two performance SLA protocols enable you to verify that the server response contains a specific value?
(Choose two.)
- A. twamp
- B. http
- C. icmp
- D. dns
Answer: B,D
NEW QUESTION # 21
Which best describes the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?
- A. Shared-policy shaping mode
- B. Per-IP shaping mode
- C. Interface-based shaping mode
- D. Reverse-policy shaping mode
Answer: C
Explanation:
Explanation
Interface-based shaping goes further, enabling traffic controls based on percentage of the interface bandwidth.
NEW QUESTION # 22
Refer to the exhibit.
Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?
- A. FortiGate has terminated the session after a change on policy ID 1.
- B. The type of traffic defined and allowed on firewall policy ID 1 is UDP.
- C. Changes have been made on firewall policy ID 1 on FortiGate.
- D. Firewall policy ID 1 has source NAT disabled.
Answer: C
NEW QUESTION # 23
Which two settings can you configure to speed up routing convergence in BGP? (Choose two.)
- A. link-down-failover
- B. holdtime-timer
- C. set-route-tag
- D. update-source
Answer: A,B
NEW QUESTION # 24
What are two reasons for using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )
- A. It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.
- B. It acts as a policy compliance entity to review all managed FortiGate devices.
- C. It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server.
- D. It sends probe signals as health checks to the beacon servers on behalf of FortiGate.
- E. It improves SD-WAN performance on the managed FortiGate devices.
Answer: A,C
NEW QUESTION # 25
Refer to the exhibit.
Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?
- A. exchange-interface-ip must be enabled.
- B. add-route must be disabled.
- C. type must be set to static.
- D. mode-cfg must be enabled.
Answer: B
Explanation:
Explanation
for using "non ike" routes (for example BGP/static and so on) you must do disable the add-route that inject automatically kernel route based on p2 selectors from the remote site from the SD-WAN_7.2_Study_Guide page 236
NEW QUESTION # 26
Refer to the exhibit.
FortiGate has multiple dial-up VPN interfaces incoming on port1 that match only FIRST_VPN.
Which two configuration changes must be made to both IPsec VPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two.)
- A. Use unique Diffie Hellman groups on each VPN interface.
- B. Use different proposals are used between the interfaces.
- C. Configure the IKE mode to be aggressive mode.
- D. Specify a unique peer ID for each dial-up VPN interface.
Answer: C,D
NEW QUESTION # 27
Exhibit.
Which conclusion about the packet debug flow output is correct?
- A. The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- B. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.
- C. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.
- D. The packet size exceeded the outgoing interface MTU.
Answer: C
NEW QUESTION # 28
Refer to the exhibits.
Exhibit A -
Exhibit B -
Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?
- A. Web filtering must be enabled on the firewall policy.
- B. Application control must be enabled on the firewall policy.
- C. Destination internet service must be enabled on the traffic shaping policy.
- D. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.
Answer: B
NEW QUESTION # 29
Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )
- A. XAuth is enabled as an additional level of authentication, which requires a username and password.
- B. The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance.
- C. A total of six packets are exchanged between an initiator and a responder instead of three packets.
- D. A peer ID is included in the first packet from the initiator, along with suggested security policies.
Answer: A,C
NEW QUESTION # 30
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
- A. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
- B. All SD-WAN rules have the default setting enabled.
- C. Traffic does not match any of the entries in the policy route table.
- D. The sdwan_service_id flag in the session information is 0.
Answer: C,D
NEW QUESTION # 31
What is the route-tag setting in an SD-WAN rule used for?
- A. To indicate the members that can be used to route SD-WAN traffic.
- B. To indicate the routes that can be used for routing SD-WAN traffic.
- C. To indicate the destination of a rule based on learned BGP prefixes.
- D. To indicate the routes for health check probes.
Answer: C
NEW QUESTION # 32
......
New Fortinet NSE7_SDW-7.0 Dumps & Questions: https://torrentlabs.itexamsimulator.com/NSE7_SDW-7.0-brain-dumps.html
